CLS2Sim software

Description

BRUNNER CLS2Sim software is a proven solution for connecting and integrating our Active Force Feedback flight simulator devices to any simulator software environment.

CLS2Sim allows extensive configuration of all our devices. Set up force by deflection and force increase with speed, control trim with and without our electric trim wheels and use the autopilot of the simulation to drive yoke, rudder or other axes.

Enable a wide range of effects like engine or runway vibrations, or stick shaker etc. for up to 20 axes connected to the CAN network.

Prepar3D®, M-FSX and X-Plane 9/10/11 are directly supported. Any third party flight simulation solution connects via a clean TCP/IP or UDP remote interface protocol which simplifies handling and reduces implementing effort to a minimum.

Read positions, buttons, forces and status information and control trim, autopilot, or force profiles for each connected axis using simple commands.

Further Information and Online Help

If you need any further help, take a look at our CLS2SIM Online Help here.

 Forum for CLS2Sim, CLS-E Yokes and Rudder

Requirements

– Operating system: Windows XP/7/8/10 needed for simulation interface software CLS2Sim

– Attention! Running X-plane (10/11) on a Linux operating system requires a separate windows installation (virtual machine or separate computer) for running CLS2sim software.

Specification

• Connect to CLS via Ethernet TCP/IP, USB
• Plug->Configure->Play Support for motorized axes: Yoke, Rudder Pedal, Cyclic, Collective, Trim Wheel, Throttle, Brakes.
• Support for any custom motorized axis over external control interface (Nose wheel, Speed brakes, etc.)
• Force/deflection curve scaling with speed
• Axis linearity, dead zones and artificial play
• Trim and Autopilot
• Motor and runway vibrations
• Prop wash effects
• Stick shaker
• Exchange your aircraft profile in the BRUNNER Profile Cloud

• Compatible with PMDG 737-800 NGX, others on request
• Supports Multi Crew-Cockpit (MCC)
• UDP or TCP/IP Interface for external control
• Linux Plugin for X-Plane
• Swiss Made